The 13001 Baseboard used together with W&T interface modules adds two isolated serial ports to your older ISA PC. The respective interface type can be freely selected by using the appropriate interface module. This makes it possible to equip your PC with different interfaces without having to use multiple cards.
Product properties:
Interfaces:
2x TTL interface
1x 16-bit ISA bus
Galvanic isolation between PC and Ports 1 and 2
Isolation voltage 1kV
Management and connectivity:
20mA, RS232, RS422, RS485 and profibus can be combined on one card
Manual configuration by means of DIL switch
Flexible configuration
Standard base addresses COM1-COM4
custom base addresses possible
Interrupts IRQ3-IRQ7, IRQ9-IRQ12
UART 16550 with FIFO
Software compatible with standard RS232 cards
No additional driver software required
Standards & more
Conforms to standards both in office and industrial environments:
High noise resistance per EN 61000-6-2
Low noise emission per EN 55032:2015 + A1 Cl. B, EN 61000-3-2 & EN 61000-3-3
5 year guarantee
Connections and displays:
System bus:
16 Bit ISA-Bus / 8.33MHz
Serial port:
2x slots for interface modules
12-pin header connector with 2mm spacing
Operating modes:
Different interface types possible
Maximum baud rate:
115.200 kbaud
Data format:
any format
Signals:
RxD,TxD,RTS,CTS,DSR,DCD,DTR,RI
Handshake:
No, RTS/CTS, Xon/Xoff
UART:
16550 with FIFO
Base addresses:
03F8H, 02F8H, 03E8H, 02E8H
Interrupts:
IRQ 3..7, IRQ 9..12
Galvanic isolation:
Isolation voltage min. 1kV DC
between PC and serial ports
Supply voltage:
5V DC, 12V DC
Current consumption:
Varies with the serial module used
Housing and other data:
Dimensions:
145 x 120mm (W x H)
Enclosure rating:
IP00
Weight:
approx. 90g
Ambient temperature:
Storage: -40..+70°C
Operating: 0..+70°C
Permissible relative humidity:
5..95% RH, non-condensing
Scope of delivery:
serial ISA mainboard
Manual
There are many cases where it is necessary to equip the ports of an interface card with different port models. It may for example be necessary to use COM1 as a 20mA programming interface for a PLC, as the software used only supports this port, while COM2 is connected to an RS232 terminal device.
For such requirements, W&T provides a very smart solution without any need for additional external hardware. The module concept of the serial W&T PC cards allow you to freely select the interface model, as the PC card mainboard is equipped with pluggable modules that convert the internal TTL signals into interface signals.
The combined interface cards are supplied fully configured according to your specifications and are ready for installation. You can change a built-in port at any time by simply replacing the interface module.
+45 75 64 33 99
info@actcom.dk
