Housing for outdoor use appropriate for W&T devices in DIN rail mount housing
With integrated 35mm support rail
Pre-stamped holes in lower housing section are provided for easy cable fitting installation (M12-M32)
Wide range of cable glands and sealing accessories available
Background information: Installing devices outdoors or in rooms with humidity and/or dust requires the use of additional protective enclosures, since these protect the electronics from environmental effects.
The polycarbonate enclosure is provided with a pre-installed 35mm support rail. The cable glands are available as separate accessories, since each application will have different requirements. Note that a cable gland is available which allows a network cable to be inserted into the housing without field-assembly of the RJ45 connector.
The unusual installation height of the enclosure with a dimension of 180mm also makes it easy to install serial W&T devices with threaded-on SUB-D connectors.
Enclosure rating (EN 60529):
IP66 / IP67
NEMA 1, 4, 4X, 6
UL 94 5V
Impact resistance (EN 62262):
Halogen-free (DIN/VDE 0472, Part 815):
Cover screw material:
Cover screw color:
Housing operating temperature:
Continuous: -40..+80°C Short-time: -40..+120°C
approx. 600 g
180 x 130 x 175 mm Dimensional drawing in PDF format
IP housing with integrated DIN rail
Send messages - when limits are violated or timer-based - for informational purposes directly to the responsible technical as an e-mail or as a reroute via SMS.
After the device has been configured for and connected to your network, the following steps are still necessary.
Open the profile for configuring e-mail alarm messages.
Enter the desired parameters.
When the limit you have set is exceeded, the device sends an e-mail which can also be transmitted as an SMS message using special functions available from cellular phone service providers.